Feedback on wire guage

[AndrewCheck]

This is the setup i am about to purchase and I was wondering if this all works....I am still confused as to what guage wiring i need in my amp kit to help me... I believe I need 4 guage. Anyways some feedback of people who know what they're talking about would help.


AMP:

Kenwood KAC-7252
2-channel 170W x 2 car amplifier


AMP Specs:

170 watts RMS x 2 at 4 ohms (250 watts x 2 at 2 ohms)
500 watts RMS x 1 bridged output at 4 ohms (4-ohm stable in bridged mode)
Wired remote control for bass boost and low-pass filter
high-pass (12 dB per octave) and low-pass (24 dB per octave) filters variable from 50 to 200 Hz
Bass boost (0-18 dB) variable from 40 to 100 Hz
Tri-way capable (Tri-Way Crossover required)
MOSFET power supply
CEA-2006 compliant
Cooling fan
Preamp- and speaker-level inputs
Preamp outputs
Requires 4-gauge power and ground leads
13-5/8"W x 2-5/16"H x 11-1/4"D


SPEAKERS:

Kenwood KFC-6959ie
6"x9" 2-way Speakers

SPEAKER SPECS:

pearl-mica injection-molded polypropylene woofer
urethane surround
1-15/16" PEI cone tweeter
recommended power range 2-50 watts RMS
peak power handling 200 watts
frequency response 28-26,000 Hz
sensitivity 92 dB
depth 2-15/16"


SUBWOOFERS:

Kenwood KFC-W2509
10" 4-ohm component subwoofer

SUBWOOFER SPECS:

pearl mica injection-molded polypropylene woofer cone
overlapping ribs on cone surface for improved rigidity and dampened resonance
urethane foam surround
extended pole piece and bumped back plate for increased cone excursion
power range 35-350 watts RMS
peak power 700 watts
frequency range 28-800 Hz
sensitivity 91 dB
top mount depth: 4-9/16"

AMP KIT:

Absolute KIT800
Amp Kit 4 GAUGE 1600W

1- 17 ft High End Gold Plated Purple RCA Cables
1- 17 ft HQ 4 Ga clear red power cable
1- 1-1/2 ft HQ 4 Ga clear red power cable
1- 16 ft 18 Ga Blue Turn-On Wire
1- 10 ft 14 Ga High End Competition Speaker Wire
1- Waterproof AGU fuse holder
1- 40 Amp AGU fuse holder
2- 4 Ga ring terminals, 1 red / 1 black
2- 4 Ga spade terminals, 1 red / 1 black
2- 14-16 GA Spaded Terminals
6- crimp caps
2- grommets
2- self-tapping screws
10 - 4"e; Cable Ties

[Google]

[sandness]

4 guage should work just fine with that amp. I'm curious, are you planning on running it in tri-mode with both the 6x9's and the sub, or are you going to use 2 amps, one for the sub and one for the 6x9's?

[wb131988]

Hey guys, haven't visited for quite a while, have been abroad for a bit getting some valuable work experience, hope everyone and their systems are OK!

Good to be home.
Dan